DAE try stacking 40 short moon shots and end up with a fuzzy blob?
Last Friday I set up in my backyard in Fresno with a cheap 70-300mm lens and shot about 40 quick frames of the moon, then ran them through a free stacking program I read about on a forum. The result was worse than any single frame I took. The edge of the moon looked soft and doubled, and the craters that were sharp in one shot turned into mush. Turns out the moon moved just enough between frames that my tripod setup couldn't keep up, and the software was blending misaligned copies instead of cleaning up noise. I learned that stacking only helps if the frames line up first, and my little ball head was drifting a few pixels each shot. Next time I'm locking everything down and shooting a shorter burst. Has anyone else had stacking make a photo worse instead of better, and how did you spot the drift before wasting a whole session?
Did you check the frames one by one before stacking? I did the same thing last month with my old 75-300 and got the same fuzzy blob. The moon drifts fast even on a "locked" tripod, so now I zoom way in on a couple frames first and watch a crater edge. If it walks around between shots, I dump the batch and reshoot with shorter gaps.