Stopped guessing at the intake grate on a barge hull job in Galveston and cut my inspection time in half
Spent two hours dragging a hand light around a clogged intake grate on a barge hull in Galveston last month, going blind on the second half because the silt was so thick. A guy on the crew told me to zip tie a small dive torch to my knife sheath facing forward, so wherever my hand went the light went with it. Sounds dumb but it dropped my time from 2 hours to 50 minutes and I actually found the debris ball wedged behind the frame that I'd missed twice before. I'm never going back to holding a light and working at the same time, it's one or the other. What little rigging tricks do you guys use when the viz goes to zero?
Two solid hours with a hand light before the zip tie trick? That is rough. Can't believe the debris ball sat there wedged behind the frame while you swept right past it twice, silt will absolutely play games with your eyes like that. The fact that a torch strapped to a knife sheath cut it down to 50 minutes is wild, mostly because the fix cost about a dollar. Going hands free just makes sense when the water is that bad, one less thing to juggle down there.