18
A customer's complaint made me rethink my coolant flush method
A guy came back after a week saying his truck was overheating again. He said, 'You just dumped the old stuff and poured new in, didn't you?' I used to do a quick drain and fill, but he was right. Now I run a chemical flush for 20 minutes, then use my machine to push three full gallons of distilled water through the system before adding the fresh coolant. His comment saved me from a comeback. Anyone have a different flush routine they swear by?
3 comments
Log in to join the discussion
Log In3 Comments
nguyen.tara22d ago
Actually, you might want to skip the chemical flush unless there's heavy scale. A lot of times just the machine flush with water is enough and it's less harsh on old seals.
6
lewis.troy21d ago
But what about the gunk you can't see? Water alone won't touch the built up sludge in the lines. Old seals are a worry, but so is low flow from blocked pipes. A mild acid flush done right is safe. It's about picking the right cleaner for the system's age. Skipping it can leave problems that just get worse.
10
noah99913d ago
My old house had a 25 year old boiler. I used a citric acid flush at half strength, ran it for only 20 minutes, and it cleared a lot of sediment without any leaks. The key is a very short contact time on older systems.
1